A demultiplexer has
- Aone input and several outputs
- Bone input and one output
- Cseveral inputs and several outputs
- Dseveral inputs and one output
A demultiplexer routes one data input to one of several outputs.
MCQs, short and long questions from lecture 19.Lecture 19 ki MCQs, short aur long sawal.
2 MCQs · 1 short · 2 long questions · 2 MCQs from past papers2 MCQs · 1 short · 2 long sawal · 2 MCQs past papers se
A demultiplexer has
A demultiplexer routes one data input to one of several outputs.
Demultiplexer has
A demultiplexer routes one data input to one of several outputs.
No MCQs match this filter.Is filter mein koi MCQ nahi.
Explain the difference between a 1-to-4 demultiplexer and a 2-to-4 binary decoder.
The circuits are almost the same. In the 1-to-4 demultiplexer the two inputs act as select lines and an extra data input is routed to the selected output; in the 2-to-4 decoder that line serves as the enable input, so the selected output is simply activated.
Write uses of demultiplexer.
1) Data distributor: routes one input line to any one of several output lines selected by the select inputs. 2) Serial-to-parallel conversion: with a counter on the select lines, serial bits are sent to separate outputs. 3) Receiving end of time-division multiplexed links: the shared line is split back into separate channels. 4) Working as a decoder: if the data input is held active, the select lines act as the address and one output is activated, so it can be used for address decoding and chip selection in memory systems. 5) Implementing Boolean functions together with OR gates, and distributing clock or control signals to selected circuits.
Uses of Demultiplexer?
A demultiplexer connects a single data source to one of several destinations chosen by the select lines. Uses: 1) at the output of an ALU, to route the result to the selected register or storage unit; 2) reconstructing parallel data from a serial data stream: a counter drives the select inputs so that successive serial bits go to successive outputs where they are stored, and the bits are then read out in parallel; 3) distributing time-multiplexed signals to separate lines in communication systems; 4) with the data input held active, working as a decoder.